Set up Robinhood Chain Beta
Create your wallet with permission, fund it, then add a follow and switch copying on.
#Before you start
- Beta unlocked.
- ETH on Robinhood Chain for gas. About 0.050 ETH is suggested. Copies are skipped when gas runs out.
- USDG to copy with, if USDG is your base currency. New accounts start in USDG. See Base currency.
#Steps
- Open Robinhood LP > Wallets. The card reads Step 1 of 2: Create your wallet and grant permission.
- Tick Let Valhalla trade from this wallet, then click Create wallet. This creates the wallet and gives Valhalla signing permission in one step, so it can act while you are offline.
- In Step 2 of 2: Fund your Robinhood LP wallet, click Add funds. A dialog shows a QR code, Your deposit address and the network, Robinhood Chain. It waits for your deposit.
- Send ETH for gas and USDG to copy with, on Robinhood Chain.
- Open Robinhood LP > Copy trade and follow a wallet. See Follow a wallet.
- Resume the follow and turn the Robinhood copying switch on.
Screenshot needed: Create wallet card
- Show
- /dashboard/robinhood/wallets at Step 1 of 2
- Highlight
- The checkbox and the Create wallet button
- Save as
assets/shots/robinhood-create-wallet.png
Screenshot needed: Deposit dialog
- Show
- The Add funds dialog with QR code and address
- Highlight
- Network and Your deposit address (blur it in the published shot)
- Save as
assets/shots/robinhood-deposit.png
#What you should see
The wallet shows its balance and a Signing permission badge: Granted. The Setup page marks the Robinhood card Ready to copy.
You can revoke permission any time under Danger zone > Revoke signing permission. If permission shows Not granted or Revoked, click Grant permission.
#If something is off
- Copies do not start: check the Robinhood copying switch is on and the follow is not paused.
- Low gas banner: add ETH. USDG-base accounts top up gas automatically by swapping small USDG amounts.
- Funds missing: make sure you sent on Robinhood Chain, not another network.